asteriondaedalus posted: " No Pins (just a package) Dual Inline Packages QUAD (pins all the way around) The way I do this is set the length to 80mm (of the 2080 variety), divide by pocket Y dimension and use the ceiling to get the actual row count (so the width may be sli"
New post on http://organicmonkeymotion.wordpress.com
The way I do this is set the length to 80mm (of the 2080 variety), divide by pocket Y dimension and use the ceiling to get the actual row count (so the width may be slightly wider than 80mm but by a proportion of a single pocket). I then centre the bisector of the screw holes so they are always centred on whatever the length becomes and they are also always 60mm apart to mount in the outer slots of the 2080 extrusion on the bed of the manual PnP.
WordPress.com
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.