So above is the test fit of the feeder, freshly off the 3D printer.
Tight fit, as the extrusion is not actually OpenBuild standard and closer to t than v slot it now seems.
Still good tight fit.
But, alas, when I went to put this setup against the assembled PnP, it turned out that the extrusion was short by some good percentage of a cm.
Not we do recall that the vendor struggled delivering the right order and some pieces were not all of the required length, so maybe one of the 4 pieces of 4020 x 300mm may be long enough, but I may again need go back to the drawing board.
CRRRRAAAAAAAAaaaaaaaappppp!
WordPress.com
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.